Ideas for alternative O-Rings

[Maurice Norcott]

I need to find a substitute for viton o-rings. It's a room temperature
application that needs to pull a light vacuum while being very compressive
(soft and pliable). The x-section profile can be square or round. Any
suggestions appreciated.



Maurice H. Norcott
Senior Technician
Silicon Genesis Corporation
61 Dagget Drive
San Jose, CA 95134-2109

408-228-5852 Office
408-977-6333 Pager
408-228-5908 Lab
408-432-3832 FAX
***@Sigen.com



_______________________________________________
MEMS-***@memsnet.org mailing list: to unsubscribe or change your list
options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
Hosted by the MEMS Exchange, providers of MEMS processing services.
Visit us at http://www.memsnet.org/

[R. Brent Garber]

That leaves you pretty much with either Neoprene or Buna-N. Any o-ring vendor
should have all three kinds.

Brent

Post by Maurice Norcott
I need to find a substitute for viton o-rings. It's a room temperature
application that needs to pull a light vacuum while being very compressive
(soft and pliable). The x-section profile can be square or round. Any
suggestions appreciated.
Maurice H. Norcott
Senior Technician
Silicon Genesis Corporation
61 Dagget Drive
San Jose, CA 95134-2109
408-228-5852 Office
408-977-6333 Pager
408-228-5908 Lab
408-432-3832 FAX
_______________________________________________
options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
Hosted by the MEMS Exchange, providers of MEMS processing services.
Visit us at http://www.memsnet.org/